Up to now, there were limits to milling wood because it often remained very fibrous and it was not possible to produce small particles. This, however, is no longer a problem for the newly developed Mikro MAK classifier mill.
 Milling and classifying in one single machine.
Production of different product qualities by altering the mill parameters, without the need for accessories or screen exchange.
Unparalleled fineness of, e.g. 99.5% < 100 µm for wood.
Exact top cut.
Throughputs between 30 and 2,500 kg/h dependent on the product and machine size.
Available in wear-protected design.
Simple and fast cleaning and maintenance.
Air humidity regulation.
Four different designs for almost any application.
Good wear characteristics of grinding elements because the rotor runs in both directions.
System concept
Figure: Mikro MAK system concept for wood flour
Qualities
Not all wood is the same, which is why a couple of examples are given below.
| Fine spruce |
1-4 mm |
10-16% |
93% < 100 µm |
8-10% |
115-125 g/dm³ |
780 kg/h |
| Coarse spruce |
1-6 mm |
8-12% |
28% < 100 µm |
6-10% |
125-140 g/dm³ |
1.100 kg/h |
| Fine pinewood |
4-8 mm |
8-12% |
98% < 100 µm |
6-10% |
100-115 g/dm³ |
780 kg/h |
| Coarse pinewood |
4-8 mm |
8-12% |
36% < 100 µm |
6-10% |
100-115 g/dm³ |
1.400 kg/h |
|
